KRILL SUKHOI 33% SPIRIT WHITE

Kit includes: Using a new composite technology, we were able to come up with extremely light airplane. And if you use a single cylinder 85ccm engine, you will get an incredible power to weight ratio!! What we would like to point out?? A high prefabrication of this ARF and it's perfect quality!- canopy and cowl are installed- alu landing gear ready to be attached- rudder servo tray glued in- bulkheads installed- fuel and smoke tank holders glued in- wings servo bays installed- predrilled location for control horns an all surface- predrill plates for different engines included- and of course a huge area in fuselage when canopy latch is removed! Simply fast and effective work !!! By our estimates, time needed to complete this airplane is around 20 - 25 hours!! That's not too bad, right? Parts description:1 - Fuselage: vacuum sandwich with all bulk heads installed, including c/f inside canopy frame2 - Wings: vacuum sandwich. Alu wing tube 40mm, each panel needs 2 servos( JR 8711).3 - Elevators: vacuum sandwich. Can be taken apart if needed. Hinge wire is a brass tubing. Each half has one mount for JR 8711. Two alu tubes 10/1mm.4 - Rudder: vacuum sandwich. Hinge wire is a brass tube, removable on the bottom, if rudder needs to be removed for transportation.5 - Canopy hatch: Alu/titanium look - comes with every kit, standard equipment. Carbon fiber - must be ordered extra. Glued into canopy frame. ..NOT RECOMMENDED TO BE USED WITH 2.4Ghz!!!!!!!!Clear ( transparent) - must be ordered extra. Glued into canopy frame. Canopy frame is fitted on to fuselage from factory. Only two M4mm screws and two wooden dowels are used.6 - Cowl: f/g part. Fitted to the fuselage and attached using 8 M4 screws. Any 80 - 120ccm size engine will fit in without any problems.7 - Landing gear: alu, with all the holes predrilled. Wheel pants are f/g. We have come up with original paint schemes for this plane.